E90 E60 E63 E83 Round Fog Light DUMBY Assembly | RFD90Based off our fog air intake, this dumby blank fog light is to complete the look of the front end of your vehicle while blocking drag from occurring on the inside of your fender liner. Bolts right up to your current bumper. Printed in a orientation to give smooth print lines for the face of the assembly Being only 110 grams, that's lighter then the OE fog assembly, that's weight reduction bro. Made for BMW E90 E91 M Sport Front Bumper M3 BMW E60 E61 5

This bracket holds your 3" air hose at a optimal position to guide all that incoming air towards the intake of your N52

Best to pair with a 3

Does not come with o-ring

have a proper cold air intake setup on your N54 chassis vehicle

Trying to add a velocity pipe for more cold air

Printed out of black TPU 95A

Measured from a stock airbox to allow for bolt in use without custom tune needed

Supplying the caps in raw form allows for:

There are all E9X and most of E82 fog light intakes available for bolt on

DOES NOT FIT N54 Throttle Body

Lifetime Warranty on 3D prints

one piece heat shield