4U Rack Mount for 8x Bee-Link EQR5 / EQR6 / EQi12 Mini PCs3D Printed 4RU rack mount for the Bee Link EQR5 EQR6 EQi12 Mini PCs. This mount was specifically designed for the around these models, so may not be compatible with older "EQ" models. The 8x PCs slide into the mount from the front and all ports are accessible from the rear. The mount has openings on the top and bottom to improve ventilation for the PCs to intake air. This listing is just for the Rack Mount, other photos showing Blanks etc are just for

or you can use 2 of these to mount a total of 8 RaspberryPi's together

3D Printed 1RU rack mount for mounting up to 4x Blackmagic Design Microconverters

Material: PETG

Also incorporates 2x Keystone sockets so you can route ports around to the Faceplate

NOTE: You will need to pair this with another ModMount item (Like a Blanking Plate (Or a second Hub Mini Mount) to make a full 1RU Width

but it would just be a looser fit without the cover on

Works for all the 3000/5000/7000 series as they share the same dimensions

The mount comes pre-assembled and you just need to remove the two back plates and then slot your devices in from the rear

3D Printed 2RU rack mount for the Bee-Link SER8 / SER9 Pro and SEi14 Mini PCs

The mount comes fully assembled and your Switch slides into the frame from the front

PRO-1U-HP-DUO (Dual PC Mount

The Mac Mini slides into the mount from the rear and then is held securely by the Rear Bracket