End mill holder Weldon with cooling channels BT 40 - 14 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw and O ring All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For sealing tools with internal cooling in collet chucks

ISO-Metric Thread

Execution:

- Scanning surface Ø24

Powder-coated

5 mm less than nominal

For mounting straight-shank tools in collet chucks DIN 6391

clamping depth l2 = max

Automatic On/Off to maximize battery life

Thread configuration with a special design

Protection level IP65

B showing the deviation of each block