Track locator sliderOur track locator slider is built tough with a 1 3 4" external slider tube and a 1 1 4" internal slider shaft on Bronze bushes. The end result is a super strong, durable and smooth sliding set up. Kit includes: 1 x 1 3 4" OD Chromoly outer tube 8" Long 2 x 1 1 4" 4140 inner slider bored for weight reduction. Accepts 3 4" UNF rod end. Pre drilled cross hole to pin the rod end to reduce movement in the thread. 2 x LG2 Bronze bushes for a longer life and

resulting in wheel spin

- Neck ribbing

- 1 x 1-1/2" x

wishbones or anything you can thing else you can think of

- 4 x Diff mounting tabs

which can cause the rear tyres to unload

It is not uncommon to be reaching speeds on the drag strip where a parachute is required to slow you down safely after a run

We factor in more strength in the common weak areas

- 2 x LH and 2 x RH 1/2" UNF rod ends with a 1/2" bolt hole (plus jam nuts to suit)

8 upper and 12 lower positions

- 1 x 1-1/4" swept upright tube 490mm long

This kit allows you to adapt a parachute to your street car