Threshed tobacco. Determination of residual stem content

with cable tie strain relief for EN 3646

the maximum material requirement (MMR) covers assembleability and the least material requirement (LMR) covers minimum wall thickness of a part

for which reference shall be made to relevant Parts of EN 1992

ESD protective packaging may be required

7 Test report

This document specifies test methods for evaluating the identified characteristics of surgical drapes and gowns and sets performance requirements for these products

Because of the increasing value of energy and variations in gas quality

which are distributed evenly on both sides of the board

BS EN 50195 also gives guidance on the precautions to be observed to avoid pollution of the environment by the correct installation

voids and bulking of aggregates about

Anyone involved in the commissioning

Recommended methods for the assessment of levels and surface regularity and for the determination of in situ crushing resistance (soundness) are also given in this standard