Diesel engines. Fuel nozzles. Size "S"1 Scope This International Standard specifies the essential dimensional requirements for size "S" fuel nozzles used in diesel engines. These requirements allow the assembly and interchangeability of the nozzles in the corresponding nozzle holders. This International Standard is applicable to size "S" nozzles, which comprise hole type, long stem nozzles (types A1 and A2) and pintle nozzles (type B). NOTE Type A1 and type nozzles are the preferred

BS EN 50396 provides best industry guidance on test methods for dimensions

or DTE internal implementation

you’d want to be sure the raw materials used are of the quality that your customers demand

and the interfacial adhesion energy is measured from the critical bending moment for the steady state cracking in the weakest interface

Hot-rolled strip and sheet/plate

giving the relative effect of different coals

The former Note 1 in 4

The basis of the decision as to whether to include pre-exposure tests is outside the scope of this standard

In their place methods based respectively on the use of a microwave oven and on the reaction of water in the aggregate with calcium carbide have been introduced

For design and special aspects of below ground drainage reference should be made to BS 8301

BS ISO 3601-2:2008 contains:

Within an organization