AIRTEC Inlet Plenum Intake Manifold (Green) - Ford Focus ST/RS MK2The AIRTEC Inlet Plenum Intake Manifold is a Gen2 design that has had months of development by AIRTEC's technicians. Features ported and polished manifold ports to match AIRTEC's lower manifold ports and comes with a 12. 5mm metal push on fitting. Heat treated for 36 hours & then pressure tested to 56PSI 4BAR of pressure to ensure maximum strength! Fits with the factory lower manifold, but when paired with AIRTEC's Lower Ported Manifold, the power

cross-flow

0 TSI EA888 engine in the VW Golf mk7 GTI

Three-piece enclosure for heat soak prevention

3 – 2004 – 2012

Sulfate ash < 0

A = 3492 cm²

quick push-in fitment into OEM subframes

It significantly improves control of engine movement and handling when used with our other competition mounts

5 Piece High performance 3-ply silicone hose kit

high-temperature material was chosen for the hood scoop and a heat shield placed between the turbocharger and the intake is included for additional heat protection

Audi – Q5 – 3

The inner and outer tubes are bonded to the rubber section to a strength of over 1000psi then stress-relieved so that all forces are distributed throughout the bonded area