High-frequency dielectric heating installations. Test methods for the determination of power output

This International Standard specifies requirements for electrically operated direct-current bilge pumps intended for use in removing bilge water from small craft with a hull length up to 24 m

NOTE The titles of the publications referred to in this part of Bs 5892 are listed on the inside back cover

automatic double-pole change-over contactors for low voltages up to 250 V employed in conjunction with storage batteries or other alternative source of supply

Rod-end with bearing in corrosion resisting steel with external threaded shank are intended for use in fixed or moving parts of the aircraft structure and their control mechanisms

Laboratory and field-testing authorities

applicable to classes ISO 35 H to ISO 45 H HEPA filters

This part of ISO 9052 applies to the determination of dynamic stiffness per unit area of resilient materials with smooth surfaces (see clause 6) used in a continuous layer under floating floors in dwellings

suspended from a suspension rig

This document also describes ways to verify the different aspects of system performance

The fundamental rules of ISO GPS given in ISO 8015 apply to this document

In this respect TPEG-Loc is not an application

It is important for a designer and manufacturer to select insulation of varnished fabrics and tapers appropriately for the their use otherwise may cause system failure