Building hardware. Cylinders for locks. Requirements and test methodsWhat is BS EN 1303 Cylinders for locks about ? BS EN 1303 is the European standard on cylinders for locks used for security and protection to keep our belonging and dwelling places safe. BS EN 1303 applies to cylinders and their keys for such locks as are normally used in buildings and are designed to be used with cylinders, where the locks have an operational torque of a maximum of 1,2 Nm. BS EN 1303 establishes one category of use, three grades of

Annex C identifies references to the project specification

Why should you use ISO 10545‑2 - Ceramic tiles

The object of installing lighting in a road tunnel is to enable traffic to flow through it with the same speed

reducing emissions to air/water and

Note: Periodic inspection and testing for arc welding equipment are covered in IEC 60974-4

This Part of PD 6512 provides guidance on the performance of glass under fire test conditions and notes some of the factors which need consideration in the design of glazed elements

— runout tolerance of locknut clamp face with respect to pitch diameter of screw thread

o Projecting: side-hung (open out or reversible) and top-hung (open out or reversible)

NOTE 2: This document does not apply to microbiological test systems for processes that rely on physical removal of microorganisms

tension straps

Clause 6 (Selection of equipment and pre-installation) and new specifications on condensate

ISO 11126-8 specifies ranges of particle sizes and values for apparent density