Shrink chuck 4,5° BT 50 - 08 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

With built-in tightening bolt

For sealing tools with internal cooling

Axial sealed with two O-rings

ISO-Metric Thread

Warranty card

clamping depth 2 mm

bores and other details

Automatic On/Off to maximize battery life

For mounting straight-shank tools and inclined flat according to DIN 1835 form E (Whistle Notch)

• runout accuracy: = 0

Extension rod

For horizontal and vertical clamping of round and flat workpieces