Pulps. Preparation of laboratory sheets for physical testing - Rapid-Koethen method1 Scope This part of ISO 5269 specifies a method, using a Rapid Kthen sheet former, for the preparation of laboratory sheets of pulp for the purpose of carrying out subsequent physical tests on these sheets in order to assess the relevant properties of the pulp itself. This part of ISO 5269 is applicable to most kinds of pulp. It is not suitable for some pulps with very long fibres, such as those made from unshortened cotton, flax and similar

and form and positional tolerances are being considered

1 that the apparatus (manual or motor-driven) and the type of cutting tool used have an influence on the test result

and long term economic viability together with maximizing the potential ecosystem

6 Measurement control system and recorder

potassium (K)

and also BS 5930:1999+A2:2010

the Bragg-Brentano configuration is addressed in most detail because of its wide use

Hybrid integrated circuits may be fully or partly completed

The temperature sensor(s) may be integrated into the recorder or remote from it [external sensor(s)]

PD CEN/TS 54-14:2018 supersedes PD CEN/TS 54-14:2004

BS EN 1398 provides you with the safety requirements for the hazards which is been identified and where the corresponding requirements is been formulated

PD IEC TS 63001 on the measurement of cavitation noise in ultrasonic baths and ultrasonic reactors is relevant to: